Then set up each entry to match mine (adjust your levels options accordingly, but my settings work so they are a good start point:Īnd make sure that you select MODE to be USB-D on the main screen. Open the settings screen and tap Connectors. This is how I have my Icom 7300 settings to control the Radio over the USB connection from a Computer for digital mode software such as JS8Call, Hamradio Deluxe and FLDigi. So you’ve got your Icom IC-7300 connected to your Computer but you can’t get JS8Call to transmit? Chances are your settings need putting right, here’s a list if settings that we know work for JS8Call. The final step is to select the Sound input and Output for JS8Call on the “Audio” tab, for Radios such as the IC -7300 you will see “USB Codec” in the name. Click on “Test CAT” if the button turns green then you’ve got it all set up for CAT control. Now open the settings window in JS8Call, go to the “Radio” tab and select your radio from the list in this example I am using the Icom IC-7300 if you have the same just make your settings the same as in the picture below. SatPC32 () Satellite Tracking - works on windows only Works with ROT2. (Preferred software) Satellite Tracking - works on Linux and MAC(with MacPorts) Works with ROT2 and MD Controllers Requires Hamlib Drivers. Radios such as the IC-7300 use the CP210x USB to UART bridge driver, so look for that in the list, make a note of the COM port name (in this case COM3. Use AlfaSpid Mode or Use Yaesu mode set to 1200,8,1,N. This will open the device manager window on your desktop.įind the entry in the list that says “Ports (COM & LTP) click the little arrow to the left of the Port Icon to see the next level down in the list, this will show the ports on your PC (you may have more than one) Then click on Device Manager in the List above To find the port (Windows 10) type “Device Manager” into the box next to the windows button

Use the original power supply or a power source with enough power. Connect the network cable, HDMI screen, keyboard and mouse and start the Raspi by plugging in the power connector. Insert the SD card into the slot of the Raspi. You should install the drive BEFORE you connect the USB cable to the Radio. First start and basic setup Raspberry Pi. For this I installed Icoms driver for my IC-7300. This assumes that you have already installed the drive for your radio. I have not tried it.Find the correct COM port and Audio – Windows 10įor JS8Call rig control to work you need to get the correct COM port selected on the settings Page. These methods of running the commercial version of HRD may work.(Warning – As of mid to late 2017, version 5.x of HRD is hard to find.

Lubuntu 16.04 (Xenial Xerus) Daily Build.Astron 20 Amp Power Supply – Kenwood PS-52 22.5 Amp Power Supply – Kenwood TS-480HX Display Resource Links are at the bottom of this page, in the video and pdf file

Ham radio deluxe for linux